Prepare your natural lashes by cleaning them thoroughly to increase durability.
1. Use a rocker bucket, gently curl your natural lashes, and then gently apply a thin and even layer of bond beneath them - slightly extends long. Make sure to brush the lashes in a single direction so that they do not stick together.
2. For thinner lashes it is recommended to apply two layers of bond, while for thicker lashes a layer is sufficient. Allow Bond to dry and become slightly sticky by waiting for approx. 20 to 30 seconds.
3. Apply lash clusters Under the bottom of your natural lashes, making sure they are located slightly away from the waterline to prevent potential irritation - about 1-2mm.
4. When you are satisfied with the application, press the lashes together to mix both the tilt band and the individual clusters - Which creates a natural look.
5. To remove any residue or excess glue, gently apply a thin layer of seal above and below your lashes, focusing on the areas where you feel it is necessary.
TIP: We recommend waiting 24 hours before bathing after the application of lash clusters. When taking a bath, avoid getting water directly on the lashes.
Removal
1. Apply ours lash cluster remover And wait for approx. 30 seconds.
2. Remove ours lash clusters
3. Apply again our lash cluster remover and wait for 1-2 minutes.
4. Repeat, if necessary, the process to ensure complete removal of any residual residues.
Recycling
Put your used ones Lash Clusters On a piece of kitchen towel, coating with Lash Cluster Remover Or oil -free makeup remover, then let sit for 10 seconds. Then fill a swab with remover and gently wipe glue residue from the lashes.
For recycling, the bucks must be completely dry.
NOTE: Recycling requires good care and careful cleansing.